Stramit® C-Clad 280

Features

• Simple Installation – “fix, hinge and cover and fix again” procedure
• 280mm Cover – for fast installation with the minimum of sheets and fasteners.
• Continuous Interlocking – to weatherseal all joints.
• Secret Fixing – fasteners are concealed from view to give a smooth appearance.
• Low Profile – for clean appearance and easy flashing and cleaning.
• Horizontal or Vertical Applications – or any angle in between, to suit almost any architectural requirement.

Applications

Stramit^® C-Clad 280wall sheeting has an appealing smooth faced finish with concealed fixings, designed for feature walling and is effective in both horizontal and diagonal applications.

Material

Stramit^® C-Clad 280 wall sheeting is a cold roll formed steel product in G300 base material (300 MPa minimum yield stress) with a Zincalume^® coating in accordance with AS1397, and Colorbond^®is available in a range of colours.

STRAMIT® C-CLAD 280 WALL SHEETING – SHEETING MASS (kg/m2 of roof area) thickness BMT Zincalume Colorbond 0.55 5.55 5.66

Pressures

STRAMIT® C-CLAD 200 WALL SHEETING – SERVICEABILITY LIMIT STATE CAPACITY span type pressure (kPa) at the spans (mm) shown 600 900 1200 1500 1800 2100 2400 2700 3000 internal 6.68 3.37 2.12 1.50 1.14 0.91 0.75 0.64 0.55 equal 6.68 3.37 2.12 1.50 1.14 0.91 0.75 0.64 0.55 double 7.45 3.76 2.36 1.67 1.27 1.02 0.84 0.71 0.62

STRAMIT® C-CLAD 200 WALL SHEETING – STRENGTH LIMIT STATE CAPACITY (Non-cyclonic) span type pressure (kPa) at the spans (mm) shown 600 900 1200 1500 1800 2100 2400 2700 3000 internal 5.57 4.02 3.13 2.56 2.16 1.87 1.65 1.48 1.34 equal 5.57 4.02 3.13 2.56 2.16 1.87 1.65 1.48 1.34 double 6.22 4.49 3.50 2.86 2.42 2.09 1.85 1.65 1.49

Impact

For wall areas likely to be subject to human impact, sheeting spans should be reduced. Impact loads will vary considerably and these are not prescribed in Australian Standards. A maximum span of 1200mm is suggested for such areas, but this should be adjusted dependant upon the exposure and importance of the application.

Fasteners All fasteners should conform to AS3566 – Class 3 and be compatible with the cladding material used. For steel – No. 10 x 16mm wafer head self drilling, self tapping screws.  For timber – No. 10 x 25mm type wafer head self drilling Type 17 screws. Add 10mm to screw length for softwood applications. Alternatively use 4mm aluminium pop rivets or 40mm flat head galvanised clouts for steel or timber respectively. Fastener Positions Use one fastener per sheet at each support placed in the pre-punched slots. For further installation information see the section later in this manual.

Product Availability 

Y - Yes     N - No     S - Subject to project size